Galaxy S4: disponibile nuovo aggiornamento leaked I9505XXUEMJ3 Android 4.3

Galaxy S4 Android 4.3

Galaxy S4 Android 4.3 leaked I9505XXUEMJ3

Nuovo aggiornamento leaked per Galaxy S4 basato su Android 4.3 I9505XXUEMJ3. Non è ancora l’aggiornamento ufficiale rilasciato da Samsung ma ci stiamo avvicinando molto alla data di roll out e dunque questa nuova leaked potrebbe essere molto simile alla versione definitiva.

  • Model: GT-I9505
  • Country: Open Asia
  • Version: Android 4.3
  • Changelist: 1840064
  • Build date: Tue, 8 Oct 2013 23:29:05 +0000
  • Product Code: OLB
  • PDA: I9505XXUEMJ3
  • CSC: I9505OLBEMJ2
  • MODEM: I9505XXUEMJ3
  • Download: I9505XXUEMJ3_I9505OLBEMJ2_OLB.zip

L’aggiornamento è ovviamente installabile tramite Odin e di seguito vi lasciamo ad alcune indicazioni facile da comprendere per chi è abituato a queste operazioni. Per coloro che non sapessero il significato dei termini a seguire, sconsigliamo l’aggiornamento visto che ormai è atteso a breve tramite OTA.

NOTE

  • – This firmware will WIPE your device (Perform a backup before flashing)
  • – This test firmware will NOT increase your binary counter NOR void your warranty.
  • – This test firmware will NOT trigger your KNOX Warranty Counter (If it’s 0×0 before flashing, it will remain 0×0 after flashing and vice versa).
  • – This test firmware is a pre-release firmware and not official from Samsung.
  • – We have fully tested this firmware and this firmware works perfectly as any other official firmware.

INSTRUCTIONS

  • – Extract (unzip) the firmware file
  • – Download Odin3 v3.09 (From here or here)
  • – Extract Odin .ZIP file
  • – Open Odin3 v3.09
  • – Restart phone in download mode (Press and hold Home + Power + Volume down buttons)
  • – Connect phone and wait until you get a blue sign in Odin
  • – Add AP_I9505XXUEMJ3_1840064_REV06_user_low_ship_MULTI_CERT.tar.md5 to AP
  • – Add BL_I9505XXUEMJ3_1840064_REV06_user_low_ship_MULTI_CERT.tar.md5 to BL
  • – Add CP_I9505XXUEMJ3_1840064_REV06_user_low_ship_MULTI_CERT.tar.md5 to CP
  • – Add CSC_OLB_I9505OLBEMJ2_1765174_REV06_user_low_ship_MULTI_CERT.tar.md5 to CSC
  • – Make sure re-partition is NOT ticked
  • – Click start button, sit back and wait a few minutes.
  • – If you encounter any issues with the firmware (Any FC, Bootloop etc)
  • – Boot into recovery mode (Home+power+vol up)
  • – Choose to wipe/factory reset. (THIS WILL ERASE ALL OF YOUR DATA INCLUDING YOUR INTERNAL SD CARD!)
  • – Then choose reboot and you should be good to go!
Email this to someoneShare on FacebookTweet about this on TwitterShare on Google+Share on LinkedInPin on Pinterest